Terminal block

Aug. 1, 1996
IDC 0.5/0.8 PCB terminal blocks eliminate wire preparation and reduce installation time. Unstripped wire is inserted into the lever actuator and pressed down to seat the wire in the contact for a gas- tight connection. Lifting the actuator enables the wire to be removed. The wire can then be reinserted or a new wire can be terminated. The system accepts solid or stranded wires and requires no stripping or terminating tools.

IDC 0.5/0.8 PCB terminal blocks eliminate wire preparation and reduce installation time. Unstripped wire is inserted into the lever actuator and pressed down to seat the wire in the contact for a gas- tight connection. Lifting the actuator enables the wire to be removed. The wire can then be reinserted or a new wire can be terminated. The system accepts solid or stranded wires and requires no stripping or terminating tools.

Phoenix Contact Inc.

Harrisburg, PA

Sponsored Recommendations

Cat 6A: The Amazingly Versatile, Capable Twisted Pair Solution

May 29, 2024
While its impossible to truly future-proof a network against challenges that dont yet exist enterprise networks can tilt the odds in their favor as they adapt to new application...

Cat 6A Frequently Asked Questions

April 29, 2024
At CommScope we know about network change and the importance of getting it right. Conclusion Category 6A cabling and connectivity.

Revolutionize Your Network with Propel Fiber Modules

Oct. 24, 2023
Four sizes of interchangeable Propel fiber modules provide the breadth of capabilities for virtually any configuration.

Elevate Your Network with Propel High-Density Panels

Oct. 24, 2023
Propel Series Sliding Fiber Optic Panels