Copper-to-Fiber Upgrade Caused FAA’s Nationwide Ground Stop

Transportation Secretary Sean Duffy said a contractor was performing ‘pretty straightforward work’ upgrading copper cabling to fiber-optic, when either human error or a faulty router caused a cascade of trouble that led to the nationwide ground stop.

Key Highlights

  • A routine telecommunications upgrade at a remote FAA site replaced aging copper lines with fiber.
  • Duffy said a router may have flooded the network with more than 1,000 connection attempts every four to five seconds.
  • The disruption affected aircraft communications and some radar feeds, prompting the FAA to stop air traffic as a safety measure.
  • The FAA’s initial investigation identified a radar site in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas, as possible sources.
  • FAA Administrator Bryan Bedford said the work was separate from the agency’s $12.5 billion modernization program.

The Federal Aviation Administration’s nationwide ground stop that was the country’s biggest news story on Friday, November 13 and through much of the weekend, was caused by a “pretty straightforward” cabling project, according to U.S. Transportation Secretary Sean Duffy. In a news conference on Saturday, November 14, Duffy laid the problem at the feet of contractor L3Harris, saying, “We haven’t determined what the fault was. Was it the router or were they not doing great work for us at L3Harris?”

Here are several quotes from Duffy’s news conference: “In at least one of our remote FAA locations, a contractor was doing routine maintenance to switch telecommunications lines from old copper wire and they were bringing it over to fiber. That contractor that does the work for us is L3Harris. They’re our legacy provider. They’ve been working with the FAA for over 20 years, and the network that we use at the FAA to control the airspace, L3Harris actually owns that network.

“… The work happening was due to the age of the copper wire that we were replacing. It was such an old wire that it was being discontinued, meaning that line was going to get shut down. So we have to switch it over from old copper. We had to bring it over to fiber going from TDM [time division multiplexing] to IP [Internet Protocol], or from analog to digital.

“I want to be clear. This work has been happening in America for decades. Virtually every single institution in America has gone from copper to fiber, from analog to digital. Maybe the FAA is the last one to be doing this work because the investments haven’t been made. But this is not complicated. It’s pretty straightforward work that we were doing [Friday] at, again, a very remote location.

“So what we’re working to determine was whether we had incompetence, meaning was it user error or install error from L3Harris, or did they install a faulty router? We haven’t determined what the fault was. Was it the router or were they not doing great work for us at L3Harris? Either through contractor error or a faulty piece of equipment, that router that was being replaced as we switched from copper to fiber, it started flooding other routers in our air traffic control system.

“So, specifically, we had over 1000 connection attempts every 4 to 5 seconds. And what that did was give us issues with our communication with airplanes and it also caused some disruption with our radar feeds. And when we see that, your safety is paramount, we shut down the airspace and we do it safely.”

Addressing the fact that the copper-to-fiber upgrade work took place on a Friday afternoon as opposed to an “off-peak” time, Duffy explained, “… because of the nature of what this switchover was, it was a remote location, we’ll do those during the day. Now, if we’re going to be at Newark, if we’re going to be, you know, in one of our big facilities, those switchovers happen at night and they can have a bigger impact. But these smaller locations don’t have that kind of impact—or they shouldn’t have that kind of impact—which is what we saw [Friday]. So there’ll be a re-evaluation of when we do this work. But when you look across the country when the work has been done from copper to fiber, going from analog to digital, they’ve happened at all times of day, and so we have to drill in a little further about what happened here.”

During the same press conference, FAA administrator Bryan Bedford emphasized the copper-to-fiber upgrade is a separate project from other upgrades the FAA is undertaking. Bedford said, “I think we’re conflating ‘modernization’ with this upgrade at this particular facility. We spend a billion dollars a year maintaining and sustaining the existing 1980s TDMI [time-division multiplexing infrastructure] telco network—call it 1G, the 1G system that the FAA is on. So we are constantly replacing 2000 Cisco 600 routers with Juniper routers. So this is ordinary course-of-business stuff. This is not part of the Peraton-FAA $12.5-billion modernization effort, so let’s not conflate those two things.”

A question-and-answer document the FAA put out on November 15 says, “The initial investigation indicates that two potential locations as the reason for the excessive data flooding the systems: a radar site in Amarillo, Texas and a radio communications site in El Dorado, Arkansas. L3Harris, the FAA’s current network service provider, had been doing work at the El Dorado site, including deployment of a new router. When these inconsistencies in the data happened, L3Harris blocked those two locations and the network stabilized. The broadcasting function was also disabled on all new routers as a precaution.”

Transportation Secretary Duffy Press Conference November 14, 2026

About the Author

Patrick McLaughlin

Patrick McLaughlin

Chief Editor

Patrick McLaughlin, content director for Cabling Installation & Maintenance and Endeavor B2B's Digital Infrastructure Group, has covered the cabling industry since the 1990s. He has authored hundreds of articles on technical and business topics related to the specification, design, installation, and management of information communications technology systems. McLaughlin has presented at live in-person and online events, has directed cablinginstall.com's webinar programs for 20 years, and administers the annual Cabling Innovators Awards.

Sign up for our eNewsletters
Get the latest news and updates